By accepting you will be accessing a service provided by a third-party external to http://www.4x4wire.com/
My spark plug socket failed to allow me to retrieve my old spark plug, which I wound up recovering with a magnetic retrieval tool. This was fine, but what about reinstalling my new plugs way “down thar”? Few of us have the fancy T-tool also used for spark plugs, so I came up with this cheap trick.
Using one of your old spark plug wires, cut the cord off near the head of the hex-shaped end of the probe. After gapping and lubing the spark plug threads with anti-seize compound, insert the plug in the end of the probe, and start threading the plug by hand back into the head. After tightening as much as you can by hand, use your spark plug socket to finish tightening the new plug and install your wire.
When pulling plugs, first loosen the spark plug with the socket, then use the old probe to grasp the top of the plug and remove it. The space where the spark plugs are mounted are tight enough to fish around until you feel the probe seat on the plug. Installing new plugs this way also allows you to feel the plug being threaded, and likely will minimize the chance of cross-threading a plug in the future.
OutdoorWire, 4x4Wire, JeepWire, TrailTalk, MUIRNet-News, and 4x4Voice are all trademarks and publications of OutdoorWire, Inc. and MUIRNet Consulting. Copyright (c) 1999-2020 OutdoorWire, Inc and MUIRNet Consulting - All Rights Reserved, no part of this publication may be reproduced in any form without express written permission. You may link freely to this site, but no further use is allowed without the express written permission of the owner of this material. All corporate trademarks are the property of their respective owners.